Navigation

    Domegaia

    • Register
    • Login
    • Search
    • Categories
    • Unread
    • Recent
    • Tags
    • Popular
    • Search
    1. Home
    2. aircrete
    A
    • Profile
    • Following
    • Followers
    • Topics
    • Posts
    • Best
    • Groups

    aircrete

    @aircrete

    0
    Reputation
    3
    Posts
    551
    Profile views
    0
    Followers
    0
    Following
    Joined Last Online

    aircrete Follow

    Posts made by aircrete

    • RE: Pumps and samples

      @hajjargibran

      After asking these questions before and seeing they go unanswered, I assume you are either speed reading or intentionally ignoring them, but either way, here goes again:

      What sort of pump would ya recommend for moving the aircrete from the barrel where mixed into a mold? I have a bad back -- among other issues, and I cannot move the heavy material around...

      As far as the pump you sell, I asked you about it by phone a while back and you most definitely did tell me that an inferior pump would work and could be purchased at some local place like Harbor Freight for less money & the entire DIY version of the little dragon could be done for give or take $100...

      I proceeded to buy the plans based on that conversation... that was right after you returned from your Mexico workshop.

      The plans do not reveal the type of pump, however, and it seems you were careful to not display the model of the pump... I don't have a problem with buying the pump from you except I just wanna build it as inexpensively as possible...

      • you didn't have any in stock at that time...

      Do you have any in stock at this time?

      Thanks

      posted in Little Dragon
      A
      aircrete
    • Samples of your aircrte blocks...

      As I have previously asked -- do you have any samples that you can send so we can have something to go by / compare our aircrete with -- to make sure we are doing this right?

      posted in AirCrete
      A
      aircrete
    • Pumps and samples

      Just ordered the parts from the wicvalve... planned on doing this way back when we last spoke but been distracted and -- as usual, sick...

      You said I should be able to use a different pump from harbor freight or some local place for less money & keep the total cost for the diy version of little dragon under $100 (+/-)...

      Which pump would ya recommend, then, and what kind of pump can be used tomove the finished (slurry mixed with foam) product into molds?

      I hope to come up with a few different molds but if you have any or sources (low cost), it would be very helpful and very appreciated...

      We have a lot of plans / ideas... the 1st test to pass will be to get the recipe right... I aim to follow your guidance that I am thus far familiar with... religiously...as I have seen the youtube videos of others trying different recipes than what you called for... just a big mess... & I think it was posted to make you (green dragon) look bad.

      Do you have any cured samples of air crete -- a block or something that you can send me? It would definitely be helpful in the beginning -- to have something with which to compare my air crete ... to make sure I'm doing it right!

      Thanks and you already have my info...

      posted in Little Dragon
      A
      aircrete